Stucco is a suitable material for protecting homes from the elements and completing the design of a home. When properly applied, stucco allows for a smooth surface that resists rain and snow damage. Stucco can be cleaned with mild soap and water or by a professional contractor. Here are some simple steps to take for basic stucco repair or replacement of damaged stucco surfaces.
Stucco Repair Jacksonville is utilized for a variety of projects that include new construction and remodeling. Loosen the old crack to at least a half-inch with a hard hammer and chisel (the edges of the damages should be even or beveled slightly in an upside-down V ‘to prevent cracks). Then break away any rotting concrete and excess material with a scrub brush. If the damage is extensive, it may require additional stucco repairs or even re-construction of the exterior.
Pre-Fabricated Stucco Repair
This method uses a quikrete pre-fabricated coating that is poured on the surface and left to cure for several hours. After the curing process, a thin layer of sanding is then performed to smoothen the surface. The entire stucco repair can be completed in about two days if there are no additional complications such as cracked or missing tiles. However, it may be necessary to remove excess fabric before sealing or applying the new coating. Since this repair requires only one coat, you will save time and expense if you do not have to wait to apply another coat.
For this Portland cement stucco repair, there are three methods that you can choose from. These are: sandblasting, scraping, or spraying. Each method has its pros and cons. For instance, sandblasting involves driving a heavy metal or stone mallet at the material to chip away the loose materials. Scraping involves using an abrasive material that has been brushed or scraped into the loose materials to chip away the loose materials until the stucco bond is reached.
In order to repair small cracks without damaging the underlying stucco layer, use scraping. This process involves using a large non-abrasive instrument to scrape away excess material until the cracks are leveled off. For larger cracks, such as those that involve the structural support of the house frame, the best option is spraying. This method involves spraying a liquid coating over the damaged area, which cures into a hard film. The repairs made by this technique are far less expensive than those done using either the sandblasting or scraping methods. Furthermore, it is also safer to work on large cracks because of the heavy duty equipment available for this purpose.
If the damage is beyond the scope of either scraping or sandblasting, then you will have to look into using the application of a metal-based remedy. Metal lath is the most common metal used in this type of remediation. The application of lath will provide a smooth surface level and a durable repair job. However, it is important to remember that the longer the time that the metal lath is applied, the more likely it is to loosen and deteriorate over time. If the damage is already extensive, then it would be best to contact a professional to assist you in this type of Portland cement repair.
There are other options available when it comes to repairing the Portland cement wall system. If the damage is very minimal, such as a small hole, then most homeowners can perform this type of Portland cement remediation without any additional tools or equipment. However, if there are underlying issues, such as cracking, buckling, or flaking, it is wise to contact a contractor who can use heavy-duty industrial equipment for the repairs. Regardless of whether you choose to repair the damage yourself or call in a professional, one thing is certain: this Portland cement repair project is no joke!
To make this task as easy as possible, always look like you can perform the repair without having to resort to any sort of fancy tools or equipment. Start by adding some concrete mix using a rubber or wooden mallet to create a smooth surface and make sure the repaired area looks like it is covered completely with water. Then, begin to sand the repaired area and smoothing it out. Finally, apply a layer of protective coating and make sure the repaired area looks like it is covered completely with water.